Try to cut 3mm Plywood, IF20 glued, wich means not waterresistant glue.
That should Work....maybe you need to run it 2 Times.
If the Laser does not cut it in 2 or 3 rounds......
Try to cut 3mm Plywood, IF20 glued, wich means not waterresistant glue.
That should Work....maybe you need to run it 2 Times.
If the Laser does not cut it in 2 or 3 rounds......
thank you very much for the help but I finally found the problem where it was and now it cuts plywood 3mm with 2 times and mdf 3mm 5 times I went through the software again and the problem happened